Recent advances www.selleckchem.com/products/bms-345541.html in air-coupled ultrasonic spectroscopy have enabled ultrasonic waves to be applied to the on-line and real-time assessment of the water content of different materials. In this study, this technique

has been applied as a non-destructive, non-invasive, non-contact, and repeatable method for the determination of water status in Populus3euramericana and Prunus laurocerasus leaves. Frequency spectra of the transmittance of ultrasounds through plant leaves reveal the presence of at least one resonance. At this resonant frequency, transmittance is at its maximum. This work demonstrates that changes in leaf relative water content (RWC) and water potential (W) for both species can be accurately monitored by the corresponding changes in resonant frequency. The differential response found between both species may be due to the contrasting leaf structural features and the differences found in the parameters derived from the P -V curves. The turgor loss point has been precisely defined by this new technique, as it is derived from the lack of significant differences between the relative water content at the turgor loss point (RWCTLP) obtained

from P -V curves and ultrasonic measurements. buy AZD0530 The measurement of the turgor gradient between two different points of a naturally transpiring leaf is easily carried out with the method introduced here. Therefore, such a procedure can be an accurate tool for the study of all processes where changes in leaf water status are involved.”
“In this research, polypropylene/wood-flour composites (WPCs) were blended with different contents see more of wood and/or maleated polypropylene (MAPP) and clay. We found that the addition of MAPP or clay in the formulation greatly improved the dispersion of the wood fibers in the composite; this suggested that MAPP or clay may have played the role of an adhesion promoter in the WPCs. The results obtained with clay indicate that it

also acted as a flame retardant. The thermal tests carried out with the produced samples showed an increased crystallization temperature (T(c)), crystallinity, and melting temperature (T(m)) with wood loading. The increase of the two former parameters was explained by the incorporation of wood flour, which played the role of nucleating agent and induced the crystallization of the matrix polymer. On the other hand, the T(m) increase was ascribed to the insulating properties of wood, which hindered the movement of heat conduction. The effects of UV irradiation on T(m) and T(c) were also examined. T(c) increased with UV exposure time; this implied that UV degradation generated short chains with low molecular weight that could move easily in the bulk of the sample and, thus, catalyze early crystallization. The flexural strength and modulus increased with increasing wood-flour content.