(a) Graphite, (b) graphene oxide film, (c to e) graphene films (reduced by ascorbic acid), and (f to j) graphene-Ag composite films (the amount of AgNO3 was from 2 to 300 mg in each film). The mechanical properties of graphene oxide films and graphene films have also been studied, as shown in Figure 10
and Table 2. Compared with graphene LBH589 oxide films, graphene films exhibit enhanced mechanical behaviors. After being reduced for 5 h, the stress of the obtained graphene films increases from 33 to 60 MPa (increased by 82%), and the strain decreases from 1.3% to 0.9%. The preliminary results, a considerable improvement in the Young’s modulus of graphene films increased by 136% (up to 7.8 MPa), are encouraging. From Table 2, it can be also observed that the optimal reduction period for the preparation of graphene films is 5 h. Moreover, after selleck Ag particles are decorated, there is little change in the mechanical properties of graphene-Ag composite films compared with the corresponding graphene films. Figure 10 Mechanical curves of the films tested by DMA. (a) Graphene oxide films and (b to d) graphene film (reduced by ascorbic acid). Table 2 Mechanical properties of
graphene oxide films and graphene films reduced for different times Sample Strain (%) Stress (MPa) Modulus (GPa) (a) GO 1.3 ± 0.2 33.0 ± 1.3 3.3 ± 0.3 (b) 1 h 0.8 ± 0.1 49.3 ± 0.9 6.8 ± 0.1 (c) 5 h 0.9 ± 0.1 60.2 ± 0.6 7.8 ± 0.1 (d) 12 h 0.9 ± 0.1 32.5 ± 1.4 3.9 ± 0.2 Finally, the sheet this website resistance of these films was measured using the four-probe detector as shown in Figure 11. The electrical properties can be tuned by the addition of a given amount of Ag particles.
When the amount of AgNO3 is no more than 10 mg, the sheet resistance decreases; on the other hand, when the amount of AgNO3 is 20 mg, the sheet resistance increases. When the optimal amount of AgNO3 is 10 mg, a minimum sheet resistance of approximately 600 Ω/□ for graphene-Ag composite films is obtained. It can be found that the conductivity of the resultant graphene-Ag composite films can be improved greatly via the uniform decoration of Ag particles. Figure 11 The electrical properties of the graphene-Ag composite films. Conclusions In summary, we have demonstrated that graphene-Ag composite films are fabricated in a Sitaxentan large scale using a facile chemical reduction method. The graphene oxide sheets can be easily assembled to form free-standing graphene oxide films during the volatilization process on PTFE hydrophobic substrate. After dipping the graphene oxide films into the Ag+ aqueous solution, Ag particles can be uniformly distributed on the surface of graphene films using ascorbic acid as a reducing agent. The morphology of the composite films can be maintained during the reduction process. The obtained films have been characterized by AFM, SEM, XRD, Raman, FTIR, TGA, DMA, and a four-probe detector.